IPT 2-Stage Self-Priming Sprinkler Booster Pump, 3,480 GPH, 3 HP, 1 1/2in., Model# 4782IPT95

A base is not offered for this model. You can bolt down the foot of the motor to a solid flat surface. You can also use support and shims under the case or foot where deemed necessary.

The model 4782-95 listed in the manual would be the one for the 3 HP.

This model does not use a grease fitting. Information on greasing the pump can be located on page 3 of the product manual. A small amount of grease or Vaseline can be applied on the outside of the shroud of the impeller opening and shaft sleeve.

This pump has two impellers. The water will go through the first impeller (first stage) and then pushes it to the second impeller (second stage) then out through the hose. An advantage would be to give you a higher PSI.

A strainer is strongly recommended. It could then handle very small granules, no larger that 1/4".

This would be possible and at 78 PSI you would get about 50-59 GPM.

This booster pump draws 18 amps, a standard 20 amp breaker would be recommended.

The water pump would need to be hardwired and can be wired to run on either 120 or 230 volts. You can put a pump starter on it if you wish. To regulate the pressure you would install a motor turn down and a pressure gauge. as you turn the motor down the pressure will drop or rise when you turn the RPM up. It is actually rated for up to 150 PSI. It is your preference if you would like to put a pressurized tank on the water pump.