To program the remote please follow the following steps:
Step 1 - Putting the Garage Door Opener into programming mode by pressing and holding the program button until the round LED turns blue, then release. The small round LED light will go out and the long LED will begin flashing purple.
Step 2- Once in programming mode, you will have approximately 30 seconds to perform this step. Pull the protective battery tab from the remote. Slowly press and release the remote button of your choice two times. The opener LEDs will flash and go off, indicating you have successfully programmed your remote. Press and release the same button a third time and door will open or close. It is possible to press the remote button too quickly or lightly. If the LEDs do not go OFF, press the remote button several more times to achieve confirmation.
