Standard Half Coupling - 1/2in. Size
The coupler I ordered was not the same part number as the one I was replacing....According to the tech info it should fit and was suprised to find it was a perfect replacement and of a much better quality...It fit perfect and is working great...
October 18, 2011
I used this coupling to replace the broken Lovejoy coupling on my log splitter. It has a 15 hp Briggs on it with 30 ton ram. I split two cords of swamp maple and it is fine. If you have never installed one, make sure it is aligned properly and make sure you leave a 1/16 gap.
June 13, 2011
This coupling worked great for my log splitter - not much else to say!
March 22, 2011
I used this to couple my 10hp Tecumseh log splitter engine to a 16 GPM Haldex pump. Installation was a snap!! The coupler fit perfectly; likewise enabling me to be up and running in no time. After numerous hours of use there are no signs of wear or any vibrations, equally attributed to a quality part!!!
July 16, 2009
I used this to join a 13.6 GPM Haldex two stage pump to a 7.5HP Briggs Vanguard engine. The pump has a 1/2 inch shaft and the engine has a 1 inch shaft. The keyway and allen screw came with the coupling so there was no need to run to the local parts store. Very easy to install and works perfectly. Just remember to leave about a 1/16 inch of clearance between the two halves and your pump will work excellent with no vibration.
November 19, 2008
These couplings do the trick
These couplings were perfect for mating my motor to a hydraulic pump for a log splitter project. I just selected the proper shaft size for the motor and likewise for the pump. I combined them with the rubber insert and now I have a direct drive from motor to pump. Thanks Northern!
November 17, 2008
Parts is parts, not always
I had a typical problem, 1/2" shaft on the pump and a 3/4" shaft on the Honda
5 hp motor. The standard coupling would not do, so the customer service
lady suggested getting one half of each coupling. Worked perfectly, with the
little rubber inserts included. I used one half part number 3002 and the other
half part number 3005. Once again Northern's assistance was great.
November 17, 2008
These half couplings are a life save whenever you are hooking up something direct drive to a motor, they save alot of time and seem to be built very strong should last quite some time.
August 11, 2008
This coupling is a must it is the easist way to join the pump and motor that i bought no vibration . took about ten min to join them together just a turn of an of a set screw and away you go .
June 18, 2008
Everything lined up pretty well but the key way needed some additional cleaning as it had a burr in it.
January 14, 2008